Dyno 2 Hot Shot Intake
68.1 Degrees Fahrenheit
Temperature difference from previous run +0.6 Degrees Fahrenheit
| 2000- to 3500 RPM HP Average: 1 | 2000- to 3500 RPM TQ Average: 2 |
| 3500- to 5500 RPM HP Average: 4-8 | 3500- to 5500 RPM TQ Average: 3-7 |
| 5500 rpm to Redline HP Average: 3-8 | 5500 rpm to Redline TQ Average: 1-2 |
| Peak Horsepower: 152.1 | Peak Torque: 162 lb-ft |
Dyno Notes
Maximum horsepower was made on a spike at redline.
Pros
Requires no cutting at all. All of the parts are complete bolt-ons.
Cons
Cold air section that goes into the fender: You might need to bend the opening a little or the intake pipe will rattle on the inner fender with the engine running. This might sound a little too picky but it would also be nice if the company had provided 10mm nuts and bolts for the MAF adapter just to keep it consistent with the factory bolt size.
Parts Included
Two-piece intake, two silicone connectors, one silicone transition connector, one air flow meter adapter, six clamps, air filter, silicone hose and one sticker.
Tools Required For Installation
Pliers, 10mm socket, 7/16 socket, ratchet, extension, 7/16 wrench and slotted screwdriver.
Install Time:
30-45 minutes